Difference between revisions of "2.5 - Concrete"
(Created page with "[https://smdltd.co.uk/technical-info/Contents '''Back to main Contents page'''] '''Concrete material''' Concrete should be specified, supplied and assessed in accordance w...") |
|||
Line 42: | Line 42: | ||
− | [https://smdltd.co.uk/technical-info/2.1_-_Fall_arrest_systems 2.1 - Fall arrest systems] | + | '''[https://smdltd.co.uk/technical-info/2.1_-_Fall_arrest_systems 2.1 - Fall arrest systems]''' |
− | [https://smdltd.co.uk/technical-info/2.2_-_Floor_deck_material_specification 2.2 - Floor deck material specification] | + | '''[https://smdltd.co.uk/technical-info/2.2_-_Floor_deck_material_specification 2.2 - Floor deck material specification]''' |
− | 2.3 - Stud welding | + | '''[https://smdltd.co.uk/technical-info/2.3_-_Stud_welding 2.3 - Stud welding]''' |
− | 2.4 - Roof deck material specification | + | '''[https://smdltd.co.uk/technical-info/2.4_-_Roof_deck_material_specification 2.4 - Roof deck material specification]''' |
− | [https://smdltd.co.uk/technical-info/ | + | ''[https://smdltd.co.uk/technical-info/2.5_-_Concrete 2.5 - Concrete]'' |
Revision as of 11:36, 24 January 2017
Concrete material
Concrete should be specified, supplied and assessed in accordance with
• BS 8500: 2015 + A1: 2016
Concrete strength class, cement type, minimum cement content, maximum water/cement ratio and aggregate weight / size should always be specified by the party responsible for the overall composite slab design, typically the project structural engineer. Approval of the intended concrete mix design/s must be sought from the relevant party prior to any concrete placement works proceeding.
Concrete surface finish
Surface finish specifications are defined in
• BS EN 13670: 2009
• National Structural Concrete Specification (NSCS) 4th edition
• Concrete Society Technical Report No. 75 – Composite concrete slabs using steel decking
For unformed finishes it is important not to over-specify the quality of finish, particularly where it is covered by following finishes. Irrespective of the finish specification, the concrete must always be fully compacted.
Concrete surface regularity
There are two common concrete surface regularity specifications used when specifying composite floor slabs
• BS EN 13670: 2009, adopted by NSCS 4th edition
• BS 8204-2: 2003 + A2:2011
Typically, the NSCS Basic or BS 8204-2 SR3 are considered applicable.
2.2 - Floor deck material specification