Difference between revisions of "7.4 - Durability"

Revision as of 12:53, 24 May 2017

All SMD decks are manufactured from galvanised steel coil to BS EN 10346 with a standard 275g/m² coating which equates to 0.02mm (20μm) per face. Although the galvanising provides a protective coating, it does weather, albeit at approximately one tenth of the rate of bare steel (depending upon the prevailing conditions).

Useful references on the life to first maintenance (LTFM) of galvanised steel coil include:

• Galvanizers Association, “The Engineers and Architects Guide: Hot-dip Galvanizing”
• Corus Strip Products UK, “Protected with strength - Solutions in Galvatite hot-dip galvanised steel”
• The Steel Construction Institute, P262 - Durability of Light Steel Framing in Residential Building: Second Edition
• SCI Advisory Desk Note 247: Use of Composite Construction in an Aggressive Environment,” New Steel Construction, April 2010.

In summary, the above references conclude the LTFM for galvanised steel coil with a 20 μm coating as shown in Table 7.4a for the different corrosivity categories.

From Table 7.4a, it is apparent that identifying the corrosivity category for the design situation is key to obtaining an accurate life to first maintenance. The environment in which the material will be located must be carefully assessed to determine which of these categories is applicable for the location in question.

The LTFM figures presented in the table above are similar to those documented by the galvanised steel suppliers for the different locations (shown below):

• Internal, Dry & Unpolluted = 20 – 50 years (Typical for most common applications – offices, warehouses, hospitals, airports)
• Suburban & Rural = 5 – 10 years
• Coastal = 2 – 5 years
• Industrial and Urban = 2 – 5 years

Refer SMD Sheet 1023 High-Durability 512 - Durability of Steel Deck Composite Floors 513 - Steel Deck Composite Floors in Car Parks

Go to NEXT section