Difference between revisions of "4.11 - End caps"
From TGN Online
| Line 1: | Line 1: | ||
| − | |||
| − | |||
| − | |||
| − | |||
Where trapezoidal (TR60+ or TR80+) decking sheets end at the perimeter of the building or at internal voids, the ends of the sheets are sealed with 0.7mm gauge galvanised end caps or polystyrene inserts. These end caps will also be required where you have a change in span direction (refer to Fig 4.11a). Due to the small re-entrant rib size of the R51 profile, sheets are typically sealed using tape or expandable foam. | Where trapezoidal (TR60+ or TR80+) decking sheets end at the perimeter of the building or at internal voids, the ends of the sheets are sealed with 0.7mm gauge galvanised end caps or polystyrene inserts. These end caps will also be required where you have a change in span direction (refer to Fig 4.11a). Due to the small re-entrant rib size of the R51 profile, sheets are typically sealed using tape or expandable foam. | ||
| Line 15: | Line 11: | ||
| − | + | Back to '''[[Contents]]''' Page | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
Revision as of 09:31, 21 March 2017
Where trapezoidal (TR60+ or TR80+) decking sheets end at the perimeter of the building or at internal voids, the ends of the sheets are sealed with 0.7mm gauge galvanised end caps or polystyrene inserts. These end caps will also be required where you have a change in span direction (refer to Fig 4.11a). Due to the small re-entrant rib size of the R51 profile, sheets are typically sealed using tape or expandable foam.
Refer to SMD Data sheet SMD.DOD.187 - TR End Closure Detail
Back to Contents Page
