Difference between revisions of "4.11 - End caps"
From TGN Online
| Line 1: | Line 1: | ||
| − | Where trapezoidal (TR50, TR60+ or TR80+) decking sheets end at the perimeter of the building or at internal voids, the ends of the sheets are sealed with 0.7mm gauge galvanised end caps or polystyrene inserts. These end caps will also be required where you have a change in span direction (refer to Fig 4.11a). Due to the small re-entrant rib size of the R51 profile, sheets are typically sealed using tape or expandable foam. | + | Where trapezoidal (TR50, TR60+ or TR80+) decking sheets end at the perimeter of the building or at internal voids, the ends of the sheets are sealed with 0.7mm gauge galvanised end caps or polystyrene inserts. These end caps will also be required where you have a change in span direction (refer to Fig 4.11a). Due to the small re-entrant rib size of the R51+ profile, sheets are typically sealed using tape or expandable foam. |
Latest revision as of 14:37, 14 August 2018
Where trapezoidal (TR50, TR60+ or TR80+) decking sheets end at the perimeter of the building or at internal voids, the ends of the sheets are sealed with 0.7mm gauge galvanised end caps or polystyrene inserts. These end caps will also be required where you have a change in span direction (refer to Fig 4.11a). Due to the small re-entrant rib size of the R51+ profile, sheets are typically sealed using tape or expandable foam.
Refer to SMD Data sheet SMD.DOD.187 - TR End Closure Detail
Back to Contents Page
Need Further Guidance?
Contact us on +44 (0)1202 718 898 or email our Technical Team
