Difference between revisions of "7.2 - Fixing tool and stud welding gun restrictions"
From TGN Online
| Line 1: | Line 1: | ||
| − | |||
| − | |||
| − | |||
| − | |||
Where deck, edge trim or shear studs are to be installed to beams with obstructions within 570mm of the top of steel level, it may not be possible to achieve the required detail on site. Consideration must be given to sequence of works and possibly the design of non-composite beams in such locations. | Where deck, edge trim or shear studs are to be installed to beams with obstructions within 570mm of the top of steel level, it may not be possible to achieve the required detail on site. Consideration must be given to sequence of works and possibly the design of non-composite beams in such locations. | ||
| Line 18: | Line 14: | ||
| − | + | Go to '''[[7.3 - Concrete encased beams|NEXT]]''' section | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
Revision as of 09:40, 21 March 2017
Where deck, edge trim or shear studs are to be installed to beams with obstructions within 570mm of the top of steel level, it may not be possible to achieve the required detail on site. Consideration must be given to sequence of works and possibly the design of non-composite beams in such locations.
Refer to SMD.DOD.164 - Fixing tool access restrictions and guidance
Go to NEXT section
