Difference between revisions of "8.4 - Standard end laps"
From TGN Online
| Line 1: | Line 1: | ||
| − | |||
| − | |||
| − | |||
| − | |||
Where the roof is laid to falls, the top flange of the supports must also be laid to falls. | Where the roof is laid to falls, the top flange of the supports must also be laid to falls. | ||
| Line 20: | Line 16: | ||
| − | + | Go to '''[[8.5 - Extended end laps|NEXT]]''' section | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
Revision as of 09:45, 21 March 2017
Where the roof is laid to falls, the top flange of the supports must also be laid to falls.
At junctions in sheet ends, the roof sheets should be overlapped by a minimum of 75mm.
The typical bearing and standard end lap details are shown in Fig. 8.4a.
Go to NEXT section
