Difference between revisions of "8.6 - Raking supports and cutting"
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
| − | |||
| − | |||
Typically roof deck sheets are supplied to site with square ends, hence where a raking end joint is required these sheets must be cut to suit on site. | Typically roof deck sheets are supplied to site with square ends, hence where a raking end joint is required these sheets must be cut to suit on site. | ||
| − | [[File:8.6a.jpg|400px]] | + | [[File:8.6a.jpg|400px|link=]] |
| Line 14: | Line 10: | ||
| − | '''Consider | + | '''Consider Off-site cutting?''' |
SMD offer an off-site cutting service, with the sheets individually detailed and cut prior to being delivered to site. This service has successfully been in place for the floor deck range for years and has added benefits of: | SMD offer an off-site cutting service, with the sheets individually detailed and cut prior to being delivered to site. This service has successfully been in place for the floor deck range for years and has added benefits of: | ||
| Line 31: | Line 27: | ||
| − | + | Go to '''[[8.7 - Cantilevers|NEXT]]''' section | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
Latest revision as of 15:39, 14 August 2018
Typically roof deck sheets are supplied to site with square ends, hence where a raking end joint is required these sheets must be cut to suit on site.
At raking joints / verges within the roof deck the sheets are to be butted together as end lapping is not possible due to the trapezoidal profile of the sheets. The support width in these locations must be sized to ensure the minimum end bearing for butted sheets can be achieved.
Careful consideration is required for sealing and provision of fillers in raking locations.
Consider Off-site cutting?
SMD offer an off-site cutting service, with the sheets individually detailed and cut prior to being delivered to site. This service has successfully been in place for the floor deck range for years and has added benefits of:
- • Reduced time working at height
- • Improved site programme
- • Less wastage at height
- • Reduced noise pollution
- • Waste recycled at source
This provides an altogether more sustainable and environmentally friendly solution.
Refer to Section 13.7 - Off-site cutting for more information
Go to NEXT section
