Difference between revisions of "8.5 - Extended end laps"
From TGN Online
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | Where sheet length restrictions mean a double span sheet is not possible, it is possible to provide extended overlaps at the junction of two single span sheets (>10% of span either side of support) to create an effective double span; Refer to Fig. 8.5a. | |
| + | [[File:8.5a.jpg|400px|link=]] | ||
| − | |||
| + | Although this is technically suitable as a detail, it is not recommended for practical reasons (ie. less economical, difficult to install, requires more detailed fixing configuration with additional fixings in webs of sheets) and should only be considered on roof deck | ||
| + | profiles deeper than 100mm (SR 135 and above). | ||
| − | |||
| − | |||
| − | |||
| − | |||
| Line 15: | Line 13: | ||
| − | + | Go to '''[[8.6 - Raking supports and cutting|NEXT]]''' section | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
Latest revision as of 13:46, 9 March 2022
Where sheet length restrictions mean a double span sheet is not possible, it is possible to provide extended overlaps at the junction of two single span sheets (>10% of span either side of support) to create an effective double span; Refer to Fig. 8.5a.
Although this is technically suitable as a detail, it is not recommended for practical reasons (ie. less economical, difficult to install, requires more detailed fixing configuration with additional fixings in webs of sheets) and should only be considered on roof deck
profiles deeper than 100mm (SR 135 and above).
Go to NEXT section
